Warbird Information Exchange

DISCLAIMER: The views expressed on this site are the responsibility of the poster and do not reflect the views of the management.
It is currently Wed May 14, 2025 3:49 pm

View unanswered posts | View active topics


Board index » General Discussion » The WIX Hangar

All times are UTC - 5 hours


Classic Wings Magazine WWII Naval Aviation Research Pacific Luftwaffe Resource Center
When Hollywood Ruled The Skies - Volumes 1 through 4 by Bruce Oriss


Post new topic Reply to topic  Page 20 of 106
  [ 1588 posts ]  Go to page Previous  1 ... 17, 18, 19, 20, 21, 22, 23 ... 106  Next
  Previous topic | Next topic 
Author Message
CAPFlyer
 Post subject:
PostPosted: Sun Dec 14, 2008 8:21 am 
Offline
3000+ Post Club
3000+ Post Club
User avatar

Joined: Fri Mar 02, 2007 6:52 pm
Posts: 3410
Location: Wichita Falls, Texas, USA
51fixer wrote:
It would have run much sooner if we had a H & S prop to install. The hub and blades hadn't been run since O/H. The prop, like other things on this beast, are a bit different and a bit complicated.
We haven't had any feed back on noise issues. This run wasn't at much power. To run any power on this you have to tie down the tail.
The Griffon has a much deeper growl than the poppin higher noise of a Merlin. I'd say the Griffon wasn't much of a noise maker and it was pretty cold so we ran it in front of the hangar.
Rich


Rich, ask Fred what I mean when I say "H&S considerations". It's not a prop manufacturer... ;)

I benefit from knowing enough people from and on that side of 'The Pond' in aviation that I've picked up far too much of the lingo for my own Texan good. :)
Top
 Profile  
 
51fixer
 Post subject:
PostPosted: Sun Dec 14, 2008 9:04 am 
Offline
3000+ Post Club
3000+ Post Club
User avatar

Joined: Tue Jul 17, 2007 9:11 pm
Posts: 3160
Location: MQS- Coatesville, PA
I have been doing my best to "Americanize" Fred and doing my best to avoid the opposite.
Cheerio,
Rich

_________________
Rich Palmer

Remember an Injured Youth
benstear.org
#64- Stay Strong and Keep the Faith

BOOM BOOM, ROUND ROUND, PROPELLER GO

Don't Be A Dilbert!
Top
 Profile  
 
Jim Beasley
 Post subject:
PostPosted: Sun Dec 14, 2008 7:24 pm 
Offline
User avatar

Joined: Sat Apr 07, 2007 10:24 pm
Posts: 392
Location: MQS (Chester County PA)
Well it's Sunday which means I'm on my own without Rich's supervision. Boy we got a lot done. Our friends Bill and Scooter Yoak showed up today and entertained Fred and me. Once we were done that, we topped off all the fluids, chased all the minor leaks, taxiied her around, ran her to zero boost, checked the prop governing. All seemed to go well.

Image

look ma no leaks
Image
Top
 Profile  
 
bentwingbomber
 Post subject:
PostPosted: Sun Dec 14, 2008 9:06 pm 
Offline

Joined: Sun Dec 19, 2004 5:23 am
Posts: 105
51fixer wrote:
I have been doing my best to "Americanize" Fred and doing my best to avoid the opposite.
Cheerio,
Rich


All i can say is rich was caught driving on the correct side of the road the other day.

the split pin,cotter pin debate continues on a hourly basis........

_________________
We salute the Rank,not the Man.
Top
 Profile  
 
51fixer
 Post subject:
PostPosted: Sun Dec 14, 2008 9:29 pm 
Offline
3000+ Post Club
3000+ Post Club
User avatar

Joined: Tue Jul 17, 2007 9:11 pm
Posts: 3160
Location: MQS- Coatesville, PA
bentwingbomber wrote:
51fixer wrote:
I have been doing my best to "Americanize" Fred and doing my best to avoid the opposite.
Cheerio,
Rich


All i can say is rich was caught driving on the correct side of the road the other day.

the split pin,cotter pin debate continues on a hourly basis........

I hope you have photographic evidence to prove your outlandish allegation sir! For sir, you have knickers in a knot. I have been a little daft lately from dealing with your dodgy aeroplane. It has me a bit tushy about tit.
Cheers
Rich

_________________
Rich Palmer

Remember an Injured Youth
benstear.org
#64- Stay Strong and Keep the Faith

BOOM BOOM, ROUND ROUND, PROPELLER GO

Don't Be A Dilbert!
Top
 Profile  
 
Moonlight
 Post subject:
PostPosted: Sun Dec 14, 2008 9:32 pm 
Offline
User avatar

Joined: Mon Apr 28, 2008 3:58 pm
Posts: 117
Location: 9S5
I just spent 2.5 weeks in Burgess Hill for training...I don't think I've ever heard "brilliant" said so many times in the course of a day.

_________________
Know why FAA inspectors always wear neckties? To keep the foreskin from slipping over their heads...
Top
 Profile  
 
51fixer
 Post subject:
PostPosted: Fri Dec 19, 2008 10:07 am 
Offline
3000+ Post Club
3000+ Post Club
User avatar

Joined: Tue Jul 17, 2007 9:11 pm
Posts: 3160
Location: MQS- Coatesville, PA
Yesterday we did the high power run.
Tied down and ready to run.
Image
Ready to howl.
Image
Start up.
Image
Running.
Image
Note the elevation of the tail wheel. It is floating a few inches off the ground.
Image
Video of idle.
Image
On to finishing things up for the DAR tomorrow.
Rich

_________________
Rich Palmer

Remember an Injured Youth
benstear.org
#64- Stay Strong and Keep the Faith

BOOM BOOM, ROUND ROUND, PROPELLER GO

Don't Be A Dilbert!
Top
 Profile  
 
Indian head
 Post subject:
PostPosted: Fri Dec 19, 2008 11:45 am 
Offline
User avatar

Joined: Tue Oct 11, 2005 3:31 pm
Posts: 71
OH WOW!!! Are they Piper Cherokees in the background??? :supz:
Top
 Profile  
 
Jack Cook
 Post subject: ??
PostPosted: Fri Dec 19, 2008 11:53 am 
Offline
Co-MVP - 2006
User avatar

Joined: Sat May 01, 2004 11:21 pm
Posts: 11471
Location: Salem, Oregon
Why isn't Rich sitting on the tail :shock: :twisted: :twisted:

_________________
Don't touch my junk!!
Top
 Profile  
 
51fixer
 Post subject:
PostPosted: Fri Dec 19, 2008 1:36 pm 
Offline
3000+ Post Club
3000+ Post Club
User avatar

Joined: Tue Jul 17, 2007 9:11 pm
Posts: 3160
Location: MQS- Coatesville, PA
Indian head wrote:
OH WOW!!! Are they Piper Cherokees in the background??? :supz:

Back to A/C ID 101 for you.
Those are Cesspools in the background.
Rich

_________________
Rich Palmer

Remember an Injured Youth
benstear.org
#64- Stay Strong and Keep the Faith

BOOM BOOM, ROUND ROUND, PROPELLER GO

Don't Be A Dilbert!
Top
 Profile  
 
51fixer
 Post subject: Re: ??
PostPosted: Fri Dec 19, 2008 1:39 pm 
Offline
3000+ Post Club
3000+ Post Club
User avatar

Joined: Tue Jul 17, 2007 9:11 pm
Posts: 3160
Location: MQS- Coatesville, PA
Jack Cook wrote:
Why isn't Rich sitting on the tail :shock: :twisted: :twisted:

We only ran it to +8 lbs of boost or around 46" mp.
We chickened out on the +12 power setting.
Rich

_________________
Rich Palmer

Remember an Injured Youth
benstear.org
#64- Stay Strong and Keep the Faith

BOOM BOOM, ROUND ROUND, PROPELLER GO

Don't Be A Dilbert!
Top
 Profile  
 
Yak 11 Fan
 Post subject:
PostPosted: Fri Dec 19, 2008 7:46 pm 
Offline
User avatar

Joined: Tue May 04, 2004 2:53 pm
Posts: 299
Location: UK
Get Fred out of it, put the cowlings on and fly it......
Top
 Profile  
 
51fixer
 Post subject:
PostPosted: Fri Dec 19, 2008 8:33 pm 
Offline
3000+ Post Club
3000+ Post Club
User avatar

Joined: Tue Jul 17, 2007 9:11 pm
Posts: 3160
Location: MQS- Coatesville, PA
Yak 11 Fan wrote:
Get Fred out of it, put the cowlings on and fly it......

Were trying to. He is having separation anxiety.
Rich

_________________
Rich Palmer

Remember an Injured Youth
benstear.org
#64- Stay Strong and Keep the Faith

BOOM BOOM, ROUND ROUND, PROPELLER GO

Don't Be A Dilbert!
Top
 Profile  
 
51fixer
 Post subject:
PostPosted: Sat Dec 20, 2008 2:56 pm 
Offline
3000+ Post Club
3000+ Post Club
User avatar

Joined: Tue Jul 17, 2007 9:11 pm
Posts: 3160
Location: MQS- Coatesville, PA
Got the Airworthiness Certificate today.
Now all we need is decent weather.
Maybe by monday.
Cheers,
Rich

_________________
Rich Palmer

Remember an Injured Youth
benstear.org
#64- Stay Strong and Keep the Faith

BOOM BOOM, ROUND ROUND, PROPELLER GO

Don't Be A Dilbert!
Top
 Profile  
 
Iclo
 Post subject:
PostPosted: Sat Dec 20, 2008 4:53 pm 
Offline

Joined: Fri Aug 04, 2006 10:20 am
Posts: 681
Location: Belgium
Don't forget you camera Rich, pleaasssseeee :twisted:

_________________
Sorry for my bad English:-(
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 20 of 106
  [ 1588 posts ]  Go to page Previous  1 ... 17, 18, 19, 20, 21, 22, 23 ... 106  Next

Board index » General Discussion » The WIX Hangar

All times are UTC - 5 hours


Who is online

Users browsing this forum: Google [Bot], phil65 and 280 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Switch to mobile style
Powered by phpBB® Forum Software © phpBB Group