L-4Pilot wrote:
The Inspector wrote:
What sort of aftermarket STOL kit is installed? (judging by the stall fences on the wings) Are you going to wash the wings in (a bit faster) or out (a bit more stable)?
Horton STOL kit installed by the DEA when they were operating the aircraft. The wings are being rigged per the service manual using the concentric bushings. Once we test fly it the wings will be adjusted as needed. Both wings were jigged and measured after rebuild and the tip washout was right on factory spec so we don't anticipate a lot of adjustment.
I understand what you are asking about the bushing and lowering or raising the inboard trailing edge and we may revisit at a later time but right now because of the extensive wing rebuild we we following the service manual on rigging to the letter.
The STOL kit will most likely slow the aircraft down one or two knots in cruise but I am fine with that.
The kit may surprise you, the Robertson STOL kits leading edge recontour actually moved the center of pressure aft a smidge and took out some of the inherent nose up built into the airplane (on the 210 kit, we actually installed a pitot head mount that was at a different angle from the factory one to compensate for the more level flight characteristics). The fences will aid some in low speed aileron control. Cessna used the R/STOL leading edge contour profile for later 172-210 models as factory, making our job that much easier by eliminating all the BONDO dust and sanding. The guys at SOLOY went even further with leading edge contours and 'tricks' making the turbine 207 a real 'tennis court' airplane.
It should be a pleasure to putt aound in-
Login
Register
FAQ
Search
