Air Brushes

Tue May 17, 2005 3:31 pm

So what do you all use, I need an upgrade the junky thing I use and want on that is going to let me bring my modeling to the next level. Without breaking the bank.

Tue May 17, 2005 8:40 pm

Iwata Eclipse HP-BCS.

It works wonder!

Wed May 18, 2005 11:12 am

I may wait a few months before trying to buy that, I may get locked out of the house. :shock:

But it does look pretty nice.

Wed May 18, 2005 1:11 pm

Mine cost me about 125$ or maybe less, it was real cheap.

I got it from Curry's in Toronto, they give stellar service and have very good prices.

Fri May 20, 2005 9:35 pm

Hi Tim,
For all the diehards out there, I still use my old Badger 200 single action. Gets the job done-looks good at 5ft or better(also known as the 5ft Rule :wink:

)
Don

Fri Jun 24, 2005 7:34 pm

Hi Tim,

Nice to see you. I just signed on for this site. See ya at HAG.

-Nathan

Mon Oct 10, 2005 3:29 pm

I’m thinking of going with the Iwata Eclipse HP-BC airbrush. I’ve used airbrushes before, I’m not total ignorant of them but far from experienced in there use.

Can I use my 5-gallon air compressor with an airbrush? I use it with my brad-nail gun and stapler so I figure that I should be ok with an airbrush. Any special adapters I will need?

What else should I be putting on my list of things I will need to get started (I have the airplane kits covered)?

Anybody recommend a spot to buy my gear from? I want an airbrush not a cyber-screwing.

Air Brushes

Air Brushes

Re: Air Brushes