Warbird Information Exchange

DISCLAIMER: The views expressed on this site are the responsibility of the poster and do not reflect the views of the management.
It is currently Wed May 14, 2025 1:09 pm

View unanswered posts | View active topics


Board index » General Discussion » The WIX Hangar

All times are UTC - 5 hours


Classic Wings Magazine WWII Naval Aviation Research Pacific Luftwaffe Resource Center
When Hollywood Ruled The Skies - Volumes 1 through 4 by Bruce Oriss


Post new topic Reply to topic  Page 15 of 106
  [ 1588 posts ]  Go to page Previous  1 ... 12, 13, 14, 15, 16, 17, 18 ... 106  Next
  Previous topic | Next topic 
Author Message
Mark V
 Post subject:
PostPosted: Mon Dec 01, 2008 4:58 am 
Offline
User avatar

Joined: Thu May 06, 2004 3:46 am
Posts: 366
Location: UK
These shots certainly show the great quality work carried out by the Fighter Collection over the last few years :)

_________________
Warbird Colour - Authentic historic aircraft finishes http://www.warbirdcolour.co.uk
Top
 Profile  
 
Jim Beasley
 Post subject:
PostPosted: Mon Dec 01, 2008 5:36 am 
Offline
User avatar

Joined: Sat Apr 07, 2007 10:24 pm
Posts: 392
Location: MQS (Chester County PA)
I flew a Mk. 14 and a Mk. 9 and then I was given the spitfire endorsement on my license. Here's a weird one --the FAA endorsement is technically "spitfir" as someone long ago who added this to the FAA regs misspelled it. And now that follows for every certification.

no doubt about TFC quality workmanship.

Lynn Allen wrote:
Jim do you have to fly something special for a differences sign off on your Spit??

Lynn
Top
 Profile  
 
JDK
 Post subject:
PostPosted: Mon Dec 01, 2008 5:54 am 
Offline
Long Time Member
Long Time Member
User avatar

Joined: Tue May 11, 2004 5:42 pm
Posts: 6884
Location: The Goldfields, Victoria, Australia
Jim Beasley wrote:
I flew a Mk. 14 and a Mk. 9 and then I was given the spitfire endorsement on my license. Here's a weird one --the FAA endorsement is technically "spitfir" as someone long ago who added this to the FAA regs misspelled it. And now that follows for every certification.

no doubt about TFC quality workmanship.

I know it's easy hits, but - No doubt about FAA 'workmanship' either. Wonder what would happen if the owner was as accurate with typos?

_________________
James K

"Switch on the underwater landing lights"
Emilio Largo, Thunderball.

www.VintageAeroWriter.com
Top
 Profile  
 
Jim Beasley
 Post subject:
PostPosted: Mon Dec 01, 2008 5:59 am 
Offline
User avatar

Joined: Sat Apr 07, 2007 10:24 pm
Posts: 392
Location: MQS (Chester County PA)
When I was registering Princess it took me three months and a ton of work to get the FAA to fix an error it made. And all the while she was grounded since the Airworthiness didn't perfectly match the Registration. ughhh.

JDK wrote:
I know it's easy hits, but - No doubt about FAA 'workmanship' either. Wonder what would happen if the owner was as accurate with typos?
Top
 Profile  
 
Jack Cook
 Post subject: ??
PostPosted: Mon Dec 01, 2008 10:26 am 
Offline
Co-MVP - 2006
User avatar

Joined: Sat May 01, 2004 11:21 pm
Posts: 11471
Location: Salem, Oregon
I think Rich should finish the P-51 first before moving to the Spit :twisted: :wink:

_________________
Don't touch my junk!!
Top
 Profile  
 
Jim Beasley
 Post subject: Re: ??
PostPosted: Mon Dec 01, 2008 11:40 am 
Offline
User avatar

Joined: Sat Apr 07, 2007 10:24 pm
Posts: 392
Location: MQS (Chester County PA)
You're a funny guy Jack I'm hoping to fly the Spit before we see a republican administration again :!:

Jack Cook wrote:
I think Rich should finish the P-51 first before moving to the Spit :twisted: :wink:
Top
 Profile  
 
51fixer
 Post subject: Re: ??
PostPosted: Mon Dec 01, 2008 1:15 pm 
Offline
3000+ Post Club
3000+ Post Club
User avatar

Joined: Tue Jul 17, 2007 9:11 pm
Posts: 3160
Location: MQS- Coatesville, PA
Jim Beasley wrote:
You're a funny guy Jack I'm hoping to fly the Spit before we see a republican administration again :!:

Jack Cook wrote:
I think Rich should finish the P-51 first before moving to the Spit :twisted: :wink:

I'm hoping it flies before we see a Democratic Administration in office.
Rich

_________________
Rich Palmer

Remember an Injured Youth
benstear.org
#64- Stay Strong and Keep the Faith

BOOM BOOM, ROUND ROUND, PROPELLER GO

Don't Be A Dilbert!
Top
 Profile  
 
51fixer
 Post subject:
PostPosted: Fri Dec 05, 2008 10:51 am 
Offline
3000+ Post Club
3000+ Post Club
User avatar

Joined: Tue Jul 17, 2007 9:11 pm
Posts: 3160
Location: MQS- Coatesville, PA
Pretty much got the fuselage back together with the tail controls in place and rigged.
Elevator is one piece end to end and attached to the horizontal with pins, collars and cotter pins. (I guess they call them split pins)
Image
The rudder is very big but light. The rudder tab is one piece but about 1/2 is displaced so there is always an air load pushing the rudder to the left. The tab also functions as an Anti-Boost tab similar to a Mustang's rudder tab. Trim tab is in the neutral position and the following pics show how it moves with the rudder.
Image
Image
Image
Image
The Griffon turns to the left. I had read somewhere that the engine turns to the left as it was developed in response to Royal Navy requirement. In a high power application on a carrier the A/C would then roll away from the tower rather than into it.
Here is some shots of the MLG uplock. This will rotate by chain and cable so that it functions as both uplock and downlock.
Image
The downlock lug of the gear is resting against the locking pin and in the lower picture the uplock lug is plated gold and visible partway down the gear leg.
Image
Hope to get the fus on jacks today.
Rich

_________________
Rich Palmer

Remember an Injured Youth
benstear.org
#64- Stay Strong and Keep the Faith

BOOM BOOM, ROUND ROUND, PROPELLER GO

Don't Be A Dilbert!


Last edited by 51fixer on Fri Dec 05, 2008 12:29 pm, edited 1 time in total.

Top
 Profile  
 
51fixer
 Post subject:
PostPosted: Fri Dec 05, 2008 12:27 pm 
Offline
3000+ Post Club
3000+ Post Club
User avatar

Joined: Tue Jul 17, 2007 9:11 pm
Posts: 3160
Location: MQS- Coatesville, PA
She is elevated.
Image
Image
Rich

_________________
Rich Palmer

Remember an Injured Youth
benstear.org
#64- Stay Strong and Keep the Faith

BOOM BOOM, ROUND ROUND, PROPELLER GO

Don't Be A Dilbert!
Top
 Profile  
 
Neal Nurmi
 Post subject:
PostPosted: Fri Dec 05, 2008 2:06 pm 
Offline
1000+ Posts!
1000+ Posts!
User avatar

Joined: Wed Mar 21, 2007 8:45 pm
Posts: 1094
Location: Kimberley, B. C. Canada
Great thread -- I'm really enjoying this one. So that odd trim tab is specific to Griffon Spits only?

What beautiful work has been done on this machine...

_________________
Neal Nurmi

---Wingman Photo---
Top
 Profile  
 
richkolasa
 Post subject:
PostPosted: Fri Dec 05, 2008 6:31 pm 
Offline
User avatar

Joined: Tue Dec 11, 2007 11:21 am
Posts: 911
Location: NJ
51fixer wrote:
Image
Hope to get the fus on jacks today.
Rich


Rich,

Do I see right-hand threads in that last image? Did the Brits turn their bolt-threads backwards along with their props? Or are right-hand threads common to WW2 aircraft in general?

Rich

_________________
Rich Kolasa
www.crystalgraphix.com
Top
 Profile  
 
51fixer
 Post subject:
PostPosted: Fri Dec 05, 2008 9:15 pm 
Offline
3000+ Post Club
3000+ Post Club
User avatar

Joined: Tue Jul 17, 2007 9:11 pm
Posts: 3160
Location: MQS- Coatesville, PA
richkolasa wrote:
Rich,

Do I see right-hand threads in that last image? Did the Brits turn their bolt-threads backwards along with their props? Or are right-hand threads common to WW2 aircraft in general?

Rich

Most things I have come across whether Brit or American has R/H threads unless there is a need due to some thing that rotates a direction that L/H thread will tend to tighten the fastener or works in combination with a R/H threaded fastener such as a turn barrel.
Rich

_________________
Rich Palmer

Remember an Injured Youth
benstear.org
#64- Stay Strong and Keep the Faith

BOOM BOOM, ROUND ROUND, PROPELLER GO

Don't Be A Dilbert!
Top
 Profile  
 
bdk
 Post subject:
PostPosted: Fri Dec 05, 2008 10:59 pm 
Offline
Been here a long time
Been here a long time

Joined: Sun May 02, 2004 1:16 am
Posts: 11319
Righty tighty, lefty loosey.
Top
 Profile  
 
Iclo
 Post subject:
PostPosted: Sat Dec 06, 2008 5:18 am 
Offline

Joined: Fri Aug 04, 2006 10:20 am
Posts: 681
Location: Belgium
I'don't remember: The Spit had flown before its departure from Duxford ?
Nice job and nice pics thanks to share them ;)

_________________
Sorry for my bad English:-(
Top
 Profile  
 
blurrkup
 Post subject:
PostPosted: Sat Dec 06, 2008 5:50 am 
Offline
User avatar

Joined: Sun Dec 24, 2006 3:12 pm
Posts: 199
Location: London
Iclo wrote:
I'don't remember: The Spit had flown before its departure from Duxford ?
Nice job and nice pics thanks to share them ;)


It didn't fly in the UK, can't remember why though.
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 15 of 106
  [ 1588 posts ]  Go to page Previous  1 ... 12, 13, 14, 15, 16, 17, 18 ... 106  Next

Board index » General Discussion » The WIX Hangar

All times are UTC - 5 hours


Who is online

Users browsing this forum: Google Adsense [Bot] and 300 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Switch to mobile style
Powered by phpBB® Forum Software © phpBB Group