For the four or five other jet enthusiasts in the forum,

here are photos of my Canadair T-33 in the middle of an annual at Heritage Aero in Rockford IL. In addition to the annual, the fuel nozzles were removed, cleaned and inspected on schedule (actually ahead of the scheduled 200 hours of engine time). You can see the soot buildup aka "coking" on the fuel nozzle underway. If left unchecked, the soot buildup can cause uneven fuel spray pattern, resulting in an uneven flame pattern, hot spots in the burner cans leading to premature wear through the can liners and an uncontained fire. Since there was coking on the fuel nozzles, we decided to check on the burner cans to ensure they didn't have any excessive soot buildup--they were fine. They also installed a new fuselage tank (just aft/under the rear cockpit) to replace the original one that was leaking. They also replaced the nose tire, and are finishing up a few minor squawks.
The canopy and the rear seat had to be removed to allow access to the fuselage fuel tank removal/installation.
[img][img]http://i96.photobucket.com/albums/l187/kep130/CT-133030107016Medium.jpg[/img]
Here's the top of the new fuel tank just aft of the rear cockpit. Jeff Fink was the A&P that did the fuel tank project and it was a nasty job. He commented that the factory must have employed 4' tall assembly technicians to get this tank into the confined space. Thanks Jeff!
[img][img]http://i96.photobucket.com/albums/l187/kep130/CT-133030107008Medium.jpg[/img]
Here's a view of the engine/plenum chamber looking aft from the rear cockpit. The long chromate colored tubes are the elevator pushrods (disconnected). The screened in area is the dual-entry centrifugal compressor (the first step of the suck, burn, blow jet engine operation process).
[/img]
Le fuselage or something like that (for our friends in Quebec)
[img][img]http://i96.photobucket.com/albums/l187/kep130/CT-133030107003Medium.jpg[/img]
Da arsse
[/img]
A "coked" up fuel nozzle prior to being sent out for cleaning.
[img][img]http://i96.photobucket.com/albums/l187/kep130/022707008Medium.jpg[/img]
One of nine burner cans being inspected for excessive soot buildup, cracks/damage in the liner. All nine checked out fine.
[img][img]http://i96.photobucket.com/albums/l187/kep130/CT-133030107001Medium.jpg[/img]
With a burner can removed, looking where the combustion gases from the burner can goes to the single stage turbine wheel.
[/img]
