Page 1 of 1
Glare shield edge padding
Posted: Tue Nov 11, 2014 8:38 am
by Smaehr
Anyone have a source for replacement of the round padding that runs along the front edge of the instrument panel glare shield. Mine has disintegrated. Lance has had it in the past but does not have any left.
Steve Maehr
SNJ5 - N3261G
Re: Glare shield edge padding
Posted: Tue Nov 11, 2014 6:45 pm
by Mustanger55
Pioneer Aero Services????
http://www.pioneeraerosvc.com/ Mostly Mustang stuff but likely has same or similar extrusions.
Norm
aka Mustanger
Re: Glare shield edge padding
Posted: Thu Nov 13, 2014 10:28 pm
by Smaehr
Thanks Norm. I will check them out.
Re: Glare shield edge padding
Posted: Fri Nov 14, 2014 12:56 am
by rcaf_100
Lance doesn't have any?
I just ordered a pair for our Harvard Mk 4 restoration at the end of September...part #88-31826-4 or 3P2-1-48
Re: Glare shield edge padding
Posted: Sat Nov 15, 2014 7:25 am
by Smaehr
Checked with them a few months back. I will try them again.
Thanks
Re: Glare shield edge padding
Posted: Fri Nov 21, 2014 6:05 pm
by Smaehr
Lance does in fact have it in stock now.
Thanks.
Re: Glare shield edge padding
Posted: Sun Nov 23, 2014 3:35 pm
by Smaehr
Got the padding from Lance. Anyone have a good technique for attaching it. It appears that several sets of holes have been drilled so I am guessing that the rubber pad was put on and then drilled for the attaching screws. I would prefer not drilling a third set of holes.