Glare shield edge padding

[Smaehr]

Anyone have a source for replacement of the round padding that runs along the front edge of the instrument panel glare shield. Mine has disintegrated. Lance has had it in the past but does not have any left.

Steve Maehr
SNJ5 - N3261G

[Mustanger55]

Pioneer Aero Services???? http://www.pioneeraerosvc.com/

Mostly Mustang stuff but likely has same or similar extrusions.

Norm
aka Mustanger

[Smaehr]

Thanks Norm. I will check them out.

[rcaf_100]

Lance doesn't have any?

I just ordered a pair for our Harvard Mk 4 restoration at the end of September...part #88-31826-4 or 3P2-1-48

[Smaehr]

Checked with them a few months back. I will try them again.

Thanks

[Smaehr]

Lance does in fact have it in stock now.
Thanks.

[Smaehr]

Got the padding from Lance. Anyone have a good technique for attaching it. It appears that several sets of holes have been drilled so I am guessing that the rubber pad was put on and then drilled for the attaching screws. I would prefer not drilling a third set of holes.