Need help identifying this part

DISCLAIMER: The views expressed on this site are the responsibility of the poster and do not reflect the views of the management.

Switch to full style
Welcome to the trans-global aviation parts market. If you have aviation related items to sell (parts, whole aircraft, or even flying squirrels) or if you need to buy something then post a message here.
Post a reply
DesertExplorer

Need help identifying this part

Wed Mar 24, 2021 8:52 pm

I found this part near Mojave, Ca recently. Approximately 2"X2"X1". CVS-43131-1 is stamped on one side and appears to be made of lead. There are scuff marks about 1/3 of the way up the slope that make it look like it was wedged under something. Any ideas?
Attachments
CVS WEDGE 1..PNG
bdk
  • bdk
  • Posts: 11319
  • Joined: Sun May 02, 2004 1:16 am

Re: Need help identifying this part

Thu Mar 25, 2021 3:11 pm

Probably a control surface mass balance weight.
DesertExplorer

Re: Need help identifying this part

Fri Mar 26, 2021 6:13 pm

Thank you bdk. That gives me an area to start digging into.
Post a reply
Switch to full style

Powered by phpBB © phpBB Group.

phpBB Mobile / SEO by Artodia.

Board index