Ken makes a good point on the flight controls and the c/p handling the yoke on landing rollout. One item that is unique to Fairchild airplanes is the automatic locking of the rudder and elevator during and after reversing. I knew that the Boxcar had this feature, but had to check to see if it was also used in the C-123. This feature was to prevent the yoke from beating the pilot to death from turbulence over the elevators during reversing. It could be unhelpful in some situations, however.
The only airplane that I flew regularly that had reverse was the DC-7 and we reversed on most landing both to shorten the landing roll and to keep the system exercised. The co-pilot definitely had to handle the yoke during reverse to keep it from flailing around from turbulence over the elevators. I once had to shut down #3 engine (right inboard) for some reason. On landing I opted to reverse the other 3 engines. Things got pretty exciting for a few moments when #4 (right outboard) went to feather instead of reverse. It’s amazing how quickly the airplane can head for the ditch with full reverse on one side only. Needless to say, I came out of reverse immediately.
The point of this being that the pilot and c/p in the C-123 would have not have the rudder available during their Mr.Toad’s Wild Ride. There is a T handle outboard of the pilot’s seat to disconnect the control lock, but that takes a free hand and a few seconds of time when you already have your hands full.
IMG_8171 by
tanker622001, on Flickr
IMG_8172 by
tanker622001, on Flickr
IMG_8173 by
tanker622001, on Flickr
IMG_8174 by
tanker622001, on Flickr