P-51 Induction Trunking needed

[Phil Earthey]

We're after induction trunking for a Mustang, the ducting that runs under the engine. Also after a few other parts, as follows:

Windscreen Frame
Oil Cooler
Elevator and Rudder balance weights
Elevator trim tabs
Rudder and Elevator trim jacks
Engine mount and parts

Any ideas most welcome. Have tried the usual suspects but am drawing a blank.

Thanks,

Phil

[Bill Greenwood]

Sorry meant that as a PM.

Last edited by Bill Greenwood on Thu Apr 12, 2007 9:14 pm, edited 1 time in total.

[Gary Norville]

Hi,

Call Jay Wisler at Warbird Parts in Tampa FL (813) 968 5048 for ALL your warbird needs.

Carl Scholl at Aero Trader in Chino CA. was making induction trunks from scratch.

I'm sure Glenn Wegman of Fighter Enterprises will leave a post, he has rebuilt our trim actuators to factory standards along with other system parts.

We (American Aero) are building aluminum tabs for our two current projects.

Good Luck

Gary Norville
American Aero Services
333 South Street
New Smyrna Beach, FL. 32168
386-423-7700

[Lynn Allen]

Nelson Ezell can make anything out of metal for any aircraft

www.ezellaviation.com

Lynn

[Yak 11 Fan]

I take it you have had a chat with the man up the road Phil? If not I can tomorrow. I know he doesn't have those part but may be able to give you some ideas.