| Warbird Information Exchange https://www.warbirdinformationexchange.org/phpBB3/ |
|
| Hurricane Parts Needed https://www.warbirdinformationexchange.org/phpBB3/viewtopic.php?f=26&t=71042 |
Page 1 of 1 |
| Author: | Dave Hadfield [ Thu Dec 19, 2019 11:08 pm ] |
| Post subject: | Hurricane Parts Needed |
Need the following for our Hurricane XII, to be flying in the spring: * Tachometer - Pioneer Gauge with RPM range 0 to 4000 * Oxygen bottle Tee Fitting - Tee fitting that comes out the top of the oxygen bottle, 1/2" BSPT at the base, 1/4" BSPP on the tee ends. Usually made of brass. * Manifold pressure gauge - Not sure who made these gauges. It does have 'CANADA' on the face with a range of -10 to 0 to 16 PSI * Vertical Speed Indicator - Made by pioneer, range is 0 to 6000 up and down * Electric thermometer - Goes in the coolant tank. Similar to the capillary type temp. probe but has a 2 or 3 pin connector on it. * Rubber dust boots - For throttle and mixture control siding rods, they are about an inch long and .5" wide. * Double acting valve rubber connectors - These rubbers are about .5" big on one end and 1" on the other. * Voltmeter - PN: 5Q/1693 24V gauge. Same as Spitfire. Range should go to 40V * Stbd side landing gear catch - This part screws into the axle of the landing gear leg and get caught by the snapjack to keep the landing gear locked up in flight. Its a sided part so its not interchangeable with the port side one. * 12 Browning .303 British machine guns?? Kidding!...Kinda Please send me a PM. Thanks, Dave |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|