C-47 wing tip removal
Posted: Tue Nov 17, 2015 1:28 pm
Hi all.
Looking for advice on the removal of a C-47/DC-3 wingtip from a wing that has been junked. I believe there are screws holding the wing end cap on but I was thinking of removing a larger section. How difficult would it be to do? Would an angle grinder be sufficient? How far out towards the tip do the front and rear spars go?
Looking for advice on the removal of a C-47/DC-3 wingtip from a wing that has been junked. I believe there are screws holding the wing end cap on but I was thinking of removing a larger section. How difficult would it be to do? Would an angle grinder be sufficient? How far out towards the tip do the front and rear spars go?
