Warbird Information Exchange

DISCLAIMER: The views expressed on this site are the responsibility of the poster and do not reflect the views of the management.
https://www.warbirdinformationexchange.org/phpBB3/

Torquing DC-3 engine mount

https://www.warbirdinformationexchange.org/phpBB3/viewtopic.php?f=26&t=56333

Page 1 of 1

Torquing DC-3 engine mount

Posted: Wed Jul 22, 2015 11:15 am
by James Dagg
Does anyone have the torque values for the engine mount to firewall bolts for a DC-3 and where that information can be found.
Thanks

Re: Torquing DC-3 engine mount

Posted: Wed Jul 22, 2015 11:15 am
by James Dagg
I should have said that the engines are Wright 1820's

Re: Torquing DC-3 engine mount

Posted: Mon Jul 27, 2015 7:38 am
by CraigQ
Check with Bill Muszala, owner of ATW Aviation in Marana AZ. Bill should be able to help you with that if you haven't found the data yet.

Re: Torquing DC-3 engine mount

Posted: Mon Jul 27, 2015 5:53 pm
by bdk
That info isn't in the maintenance manual? Aren't the QECs usually removed and reinstalled at those points?
All times are UTC - 5 hours
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/