Hi All
What would be the prefered method to bleed the brakes for a BT?. The book says to start from the top down but some folks like to start from the bottom up.
Thanks - Mark D
| Warbird Information Exchange https://www.warbirdinformationexchange.org/phpBB3/ |
|
| Bleeding brakes https://www.warbirdinformationexchange.org/phpBB3/viewtopic.php?f=26&t=33385 |
Page 1 of 1 |
| Author: | Mark D [ Thu Dec 03, 2009 11:04 am ] |
| Post subject: | Bleeding brakes |
Hi All What would be the prefered method to bleed the brakes for a BT?. The book says to start from the top down but some folks like to start from the bottom up. Thanks - Mark D
|
|
| Author: | Second Air Force [ Thu Dec 03, 2009 12:20 pm ] |
| Post subject: | Re: Bleeding brakes |
I've always preferred bottom up. Make certain to monitor the level in the reservoir, though. They fill up faster than one would think! Scott |
|
| Author: | skymstr02 [ Thu Dec 03, 2009 7:04 pm ] |
| Post subject: | Re: Bleeding brakes |
I've had better results from the bottom up also. Seems to get the air out of the lines best. I put a hose on the vents on the master cylinders, put the other end of the hose in a clean bottle, and let the fluid flow. No mess. |
|
| Author: | N3Njeff [ Thu Dec 03, 2009 7:28 pm ] |
| Post subject: | Re: Bleeding brakes |
skymstr02 wrote: I've had better results from the bottom up also. Seems to get the air out of the lines best. I put a hose on the vents on the master cylinders, put the other end of the hose in a clean bottle, and let the fluid flow. No mess. Exact Ditto! keep goin from the bottom up when the air disapears in the clear tubing off the master. That being said, if you fill it slow enough, you should pretty much get it. |
|
| Author: | Matt Gunsch [ Thu Dec 03, 2009 11:04 pm ] |
| Post subject: | Re: Bleeding brakes |
I'll echo what others have said and add this, sometimes to get stubborn air bubbles you might have to slowly work the brake pedals as you are bleeding them. |
|
| Author: | Oscar Duck [ Fri Jan 22, 2010 1:43 am ] |
| Post subject: | Re: Bleeding brakes |
problem with my Bird Dog brakes. Has Cleveland's.. Brakes good, pedal hard... parked for three months, no got pedal on either side. no fluid visible anywhere. Cylinders down a bit. any ideas welcome... |
|
| Author: | Bug_racer [ Fri Jan 22, 2010 7:53 am ] |
| Post subject: | Re: Bleeding brakes |
Oscar Duck wrote: problem with my Bird Dog brakes. Has Cleveland's.. Brakes good, pedal hard... parked for three months, no got pedal on either side. no fluid visible anywhere. Cylinders down a bit. any ideas welcome... you have to have a leak somewhere . bleed at each nipple and check if any air comes out at that particular nipple , if it does then that curcuit has a leak Im no aircraft mechanic but speaking from logic you always start from the bottom and go up . Air tends to naturally rise to the top . Do planes have bleed nipples on the master cylinder as well ? |
|
| Author: | skymstr02 [ Fri Jan 22, 2010 6:06 pm ] |
| Post subject: | Re: Bleeding brakes |
Bug_racer wrote: Do planes have bleed nipples on the master cylinder as well ? Some of the older WWII vintage airplanes do, but not with Cleveland brand brakes |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|