| Warbird Information Exchange https://www.warbirdinformationexchange.org/phpBB3/ |
|
| Question on Carb Mixture Temp gage pegging with master on https://www.warbirdinformationexchange.org/phpBB3/viewtopic.php?f=26&t=32043 |
Page 1 of 1 |
| Author: | Mark D [ Tue Sep 15, 2009 1:04 am ] |
| Post subject: | Question on Carb Mixture Temp gage pegging with master on |
In the BT we have an AN5525-1 resistance bulb from Banaire. It also says Edison Splitdorf B2201. The carb temp gage is a F-9, 12 volt. When I ohm out the contacts in the probe, I get between 140 and 150 ohms. Is there a posible mismatch in resistance between the gage and the probe that makes the needle peg?? Mark D |
|
| Author: | 51fixer [ Mon Sep 21, 2009 12:25 pm ] |
| Post subject: | |
Mark, Check the wiring. I know that if I disconnect a probe the needle will peg as well. Rich |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|