Does anybody else out there think we need another model of the Huey in either 1/35 or 1/32?
I have both the Revell 1/32 and the Panda/Dragon 1/35 Huey kits.
For some reason most of the modelers I meet seem to prefer the Panda/Dragon kit. Mostly, I think because the Revell kit is dated and a bit simplified. Especially in the interior.
Before I go on, I want to establish my "bona fides". I enlisted in the US Army in 1980 as a 67N, which to you non Army types is a Utility Helicopter Repairer; or Huey Mechanic. I remained a Huey Mechanic/Crewchief until 2008 when they hauled me kicking and screaming from the last one in on our Inventory. Because of a paperwork glitch I ended up being the last Soldier in the Army to carry a 15M ( the new 67N) MOS in the Army; as my primary MOS.
Now the Revell Huey has very accurate panel lines. And has an acceptable Engine. At least as a starting point! I agree that, aside from the floor, transmission housing and center console that the interior kinda sucks. I will say that the texture on the sound deadener on the Transmission housing is well done, as is the cabin floor.
Now the Panda model has a much nicer interior, though it is heavy handed in spots, and some of the little details like the 90 degree gear box are better represented. And I like the PE.
However! The exterior detail is just plain WRONG. The panel lines are wrong. The rivet detail is WAY overdone, and I have never seen a door on the tailboom of any UH-1 D/H/V aircraft. Yes I have seen pictures of access doors aft of the rear battery compartment. But those aircraft were not the model represented by those kits.
Right now I am kitbashing those two models to make an acceptable representation of a Huey. Will it scale out completely correct. Probably not. Will it be noticable? Not so far!
I am actually building two models of the same tail number. One as she appeared in Vietnam. The other as she appeared in 2008.
So; anyone agree with me on this?
|